Master collets are made from hardened alloy steel, and are precision ground to very close tolerances to assure best accuracy and long term performance. Master collets are supplied with clamp screws.

 
Collet Pad Model Master Collet Model Chuck Model
S-16 SK46BZI/S16 CB46 Series
S-20 SK65BZI/S20 CB65 Series
S-22 SK65BZI/S22 CB65 Series
S-26 SK80BZI/S26 CB80 Series
S-30 SK80BZI/S30 CB80 Series
S-35 SK100BZI/S35 CB100 Series

 




Collet installation fixtures are used to insert and remove the master collet from the collet chuck. Removal of the master collet is necessary only when removing the chuck from the machine or during maintenance when the collet chuck is being cleaned.

 
Fixture Model Master Collet Model Type Chuck Model
CM46 S-16 Manual CB46 Series
CM65 S-20 & S-22 Manual CB65 Series
CM80 S-26 & S-30 Manual CB80 Series
CP100 S-35 Pneumatic CB100 Series

 

 

 

Ejectors for sub spindle collet chucks are mounted inside the chuck behind the master collet. It is not necessary to remove the collet chuck from the machine to install the ejector.

 
Ejector Model Chuck Model
AW-CB46/S CB46-NS/S
AW-CB65/S CB65-NS/S