High Clamping Force.....
Parallel clamping design generates higher clamping forces than traditional collet and three jaw chucks

 

Low Profile Design.....

• Short overall length for maximum Z axis utilization
• Reduced OD for increased tool clearance

 

High Spindle Speeds .....
• Up to 6,000 rpm

Large Clamping Range.....
• +/- .020" (0.5 mm) range to accommodate variations in bar stock diameter


 

Superior Rigidity.....
•

Shorter overall chuck length
•

Workpiece is machined closer
to spindle face
•

High chuck rigidity improves
cutting tool life and allows
higher metal removal rates for
shorter cycle times



 

Vulcanized Master Collet.....
MicroCentric has manufactured a vulcanized Quick Change Collet System for over 15 years, and utilizes this technology to bring you a new series of Master Collet Chucks of unmatched design, performance, and features. The vulcanized rubber is specially formulated to be resistant to coolants and cutting oils. The bond between rubber and metal is permanent and is guaranteed for the life of the collet.